11
GB
O R I G I N A L I N S T R U C T I O N S
the front of the dust container. It is permissible to vacuum soft sur-
faces, e.g. carpets, upholstery, etc. without an installed attachment
or hose.
The
fl
exible hose joint without the embossed part is designed to be
inserted into the opening of the dust container and the joint with the
embossed part should be inserted over the tip.
The brush attachment is used to clean surfaces that can be easily
scratched. The narrow tip attachment is used to clean hard-to-reach
areas.
Preparing for operation
Check the vacuum cleaner tank, empty it of waste, if necessary.
Check the
fi
lter. If the
fi
lter is dirty, dry clean with a compressed
air stream of no more than 0.3 MPa or wet under a stream of run-
ning, lukewarm water. Do not clean the
fi
lter in dishwashers or with
a high-pressure water jet. If dirt cannot be removed from the
fi
lter,
replace it with a new one. Check the condition of the
fi
lter seals,
replace the
fi
lter with a new one if they show damage.
CAUTION!
It is forbidden to work with a vacuum cleaner without a
properly installed air
fi
lter. This can cause damage to the vacuum
cleaner as well as electric shock.
Wor king with a vacuum cleaner
CAUTION!
It is forbidden to use a vacuum cleaner to vacuum hot
ashes. The temperature of waste suctioned by the vacuum cleaner
must not exceed 40 ° C.
Make sure that all preparatory work has been carried out correctly.
Make sure that the vacuum cleaner switch is in the “OFF” position.
Insert the plug of the power cord into the mains socket and the LED will
light up on the plug. Then move the switch to the “ON” position (VIII).
After
fi
nishing work, turn o
ff
the vacuum cleaner using the on/o
ff
switch, and then unplug the power cord from the mains socket. Start
the maintenance of the vacuum cleaner.
If the LED does not light up when the plug is connected and the
vacuum cleaner does not work, the fuse in the plug may burn out.
If this is the case, replace it with a new one. To do this, unscrew
the mounting ring, remove the plug contact and the fuse. Install in
reverse order (IX).
Caution! If suspicious vibrations, a drop in thrust force or noisier mo-
tor operation are observed during operation, this may mean that the
tank is full or that the
fl
exible hose or suction attachment is clogged.
In this case, turn o
ff
the vacuum cleaner immediately with the switch
and unplug the power cord from the mains socket. Then empty the
tank and check the permeability of the
fl
exible hose and attachment.
Restore patency if necessary. If it is not possible to restore patency
of the
fl
exible hose or the suction attachment, replace them with new
ones before continuing to work.
Maintenance of the vacuum cleaner
Caution! Before carrying out any maintenance work, make sure that
the power cord plug has been disconnected from the mains socket
of the power system.
After each use of the vacuum cleaner, check the tank, lid seal and air
fi
lter as described in the section:
“Preparing for operation”.
Clean the vacuum cleaner from the outside and the
fi
lter with a
stream of compressed air of not more than 0,3 MPa. Special at-
tention should be paid to the permeability of ventilation openings,
both inlet and outlet openings. Clean them with a stream of com-
pressed air of not more than 0,3 MPa, if needed. Do not use sharp,
metal objects for cleaning the ventilation openings. Do not immerse
the vacuum cleaner in water to clean it. Check the vacuum cleaner
hose for damage after and before each use. It is forbidden to use a
damaged hose.
Remove larger dirt from the housing with a soft cloth.
