Stewart Filmscreen – Luxus
16
IR WALL SWITCH AND REMOTE (IF EQUIPPED)
A 3-button IR (infrared) remote control (see Figure 10) is supplied in conjunction with the 3 button IR
(infrared) wall switch (see Figure 15) for the IMC (see Figure 11). The IMC control board comes ready to be
operated via IR and projector trigger right out of the box. You may visit StewartFilmscreen.com for a full
list of IR Hex codes if you want to program the IR to another remote. Instead of receiving an IR receiver
eye, you will get a wall switch with the eye built in.
GETTING STARTED
Making the Connections
1.
Connect the RJ25 cable to the back of the IR wall switch (see
Figure 16).
2.
Connect the IR wall switch cable with RJ25 end to the back of
Luxus on the smart port with RJ45 as shown (see Figure 12).
3.
Install the IR wall switch anywhere in the room, making sure that
there are no obstructions between the eye and the screen.
4.
Keep note that you may want to hide the cable inside your wall
to ensure a clean install.
Note
: Luxus comes with two RJ45 female inputs. The maximum
length of the RJ45/RJ25 cable plugged into the unit shall not
exceed 50’. Dry closure modules from any home automation
system can be interfaced, utilizing up/down/common type
terminations only on the dry contact port.
OPERATION
After the screen has been properly mounted, check that the
batten retainers have all been removed. Using the IR remote,
press the “down” button and the Luxus screen will automatically
extend fully to its preset limit and will power itself off. Press the
“up” button once and the Luxus screen will automatically retract
back into the case and power itself off. If a custom position is
desired, simply press the “stop” button at any time during the screen’s deployment or retraction.
Note
: See the section, “Adjusting Screen Deployment” (see Page 24), for information regarding the default
limits to which the screen can be adjusted up or down from the factory preset.
Figure 15. Front of IR wall switch
Figure 16. Rear of IR wall switch with
RJ25 input
