Luxus
11
OPERATION:
Press the “Down” button once, and the Luxus screen will automatically extend fully to its pre-set limit,
and then will power itself off Press the “Up” button once and the Luxus screen will automatically retract
back into the case and power itself off If a custom position is desired, simply press the “Stop” button at
any time during the screen’s deployment or retraction
Note:
See the section on Adjusting the Screen Extension for information regarding the default limits to
which the screen can be adjusted up or down from the factory pre-set
STANDARD CONTROL – PROJECTOR TRIGGER
1 Connect a projector trigger cable to the projector (Note: projector trigger cable is not provided
– the installer needs to make the cord from a RJ25 cord, cut one end off and add the mono plug
onsite )
2 Connect the other end of the trigger cable to the Luxus unit (RJ25 plug)
HOW IT WORKS
When a trigger signal equipped projector is turned on or off, a voltage is either supplied or withdrawn,
via a class II, two conductor wire, connected to the screen The projector delivers 12 volts or even as low
as 5 volts when it is powered The screen control interprets this voltage as a prompt to deploy the fabric
If there is a sudden change in voltage, the motor is paused for ½ second before reversing direction
This is to prevent strain on the motor mechanism, and to prevent damage to any material controlled by
the motor When the projector and screen are energized, the control system relay is also energized In
the retracted position, relays are automatically de-energized after 120 seconds of operation to reduce
power consumption
ELECTRICAL (CONTINUED)
