6
Stewart Filmscreen
INSTALLATION: AT FRAME
ASSEMBLING THE FRAME
Frame members and corners are numbered to make assembly easier
1 As you unpack the frame, check the corners and tube ends for numbering
2 On the clean work area, lay out the tubes; if masked, the masking side should be down Make sure to
align the corresponding numbered ends
3 Assemble the frame components using the supplied bolts A back brace is used for front projection
screens over 16’ / 4 8 m wide that use a T-stand or stage fly mount
4 Proceed to the instructions for the wall mount support system, stage fly mount, or the T-stand
Note for larger frames
On larger frames, it may be necessary to install the frame directly to the mounted position
`
`
Mount one frame member at a time, assuring proper placement on the wall or in the aperture
`
`
Begin at the bottom corner and work across to complete the bottom Then mount the side frame
members followed by the top
`
`
As you proceed, check that frame members are level
3
3
4
4
2
2
1
1
5
5
6
6
Figure 2: Frame members aligned according to numbered ends.
