Final Assembly Continued
☐
Connect electronic speed control (ESC) to
motor leads and tuck back within the hatch.
☐
Make connections to receiver for rudder servo
(to aileron channel) and throttle. Route
antenna through antenna mast tube and
secure receiver within hatch using velcro.
☐
Test fit battery within electronics hatch and
adjust / neaten up routing of wires.
☐
Mount propeller to motor using supplied collet
adapter. Propeller size designation should
face FORWARD.
Tip! Consider upgrading to
the set screw adapter (EFLM1930)
☐
Center hatch cover to hatch gasket then slide
the “hooks” of the cover forward until cover
seats properly compressing the forward part
of the hatch gasket.
☐
Retain hatch with the provided #2 x 7/16 in.
screws.
© 2010 Stevens AeroModel all rights reserved. V2.0 (11.10.2014)
Page 18 of 25
