Final Assembly Continued
☐
Install rudder post with bushing seated
against deck top. Retain with CA glue.
☐
Mount rudder servo using hardware supplied
by servo manufacture. Temporarily connect
servo to radio and center electronically.
☐
Glue plywood rudder mount and control arm
to rudder as illustrated below with control arm
on same side as servo.
☐
Make up a 6 in. extension for the motor from
16AWG wire and 3.5mm bullets connectors.
☐
Mount brushless motor to motor mount using
four provided No. 2 x 1/2 in. screws. Cut two
3/16 in. lengths of the provided silicone tubing
and use to shim the right side of the motor
(when viewed from stern of boat).
☐
Thread motor supply leads and servo wire
through hole between front and rear hatch.
© 2010 Stevens AeroModel all rights reserved. V2.0 (11.10.2014)
Page 16 of 25
