Project Checklist
Kit Contents
☐
Laser Cut Wood (6 Sheets)
☐
Build Instructions
☐
Computer Drawn Detail Page
Taped to back of wood brick
☐
1 - 0.025 in. x 12 in. wire (landing gear)
☐
3 - 0.015 in. x 12 in. wire (pushrods)
☐
1 - 1/16 x 1/8 in. laser cut basswood stock
☐
Hardware Bag
1 - 2 in. Length of 1/16 in. Heat Shrink Tube
1 - 1 in. Length of 1/32 I.D. Yellow Nylon Tube
2 - Bell Crank Mounting Pins [DUB918]
3 - 1/16 in. x 1/4 in. Aluminum Tubes
4 - Foam Wheel Blanks
Suggested Electronics and Other Equipment(Available at StevensAero.com)
☐
DSM2 Compatible Spektrum Transmitter with at least 4 channels
☐
DSM2 Compatible Spektrum Ultra-Micro Receiver/ESC/Servo Brick (short throw) [SPMAR6400]
☐
1.5g Linear Ultra-Micro Servo (short throw) [SPMAS2000]
☐
Motor/Gearbox [PKZ3624]
☐
130mm x 70mm Propellor [EFL9051]
☐
160 mAh 3.7V LiPo Battery [LG325-0160-1S-UM]
Required Building Supplies and Tools
☐
1/2 oz. Thin CA Glue [PAAPT09]
☐
1/2 oz. Medium CA Glue [PAAPT03]
☐
1 oz. Thick CA glue [PAAPT20]
☐
CA glue applicator tips [PAAPT21]
☐
Hobby Knife with ample supply of #11 blades
☐
Sanding block with 400 and 600 grit paper
☐
Heat Gun and Covering Iron
☐
Small Needle Nose Pliers
☐
1/2 in. wide clear tape [DUB916]
☐
Hook and Loop (Velcro) Set [PKZ1039]
☐
Servo Tape [DUB634]
Optional Building Supplies and Tools
☐
CA glue accelerator [PAAPT15]
☐
CA glue de-bonder [PAAPT16]
☐
Long sanding bar
☐
Masking Tape (Low tack blue painters tape)
☐
Modeling Clay
Build Instructions September 8, 2011
!
(c) 2011 Stevens AeroModel all rights reserved.
!
Page 3
