Build Instructions
23. Hold center section of wing flat on a smooth
surface, checking that both wing tips are an
equal distance above the surface.
24. Fit and bond trailing edge W14 between ribs
W3.
25. Fit and bond leading edge webbing W15
between ribs W3.
26. Fit and bond leading edge W16 between ribs
W3.
27. Fit and bond ply trailing edge support W17 to
notch on trailing edge center section.
28. Using 400 grit sand paper and a sanding
block, lightly sand exterior edges of wing in
preparation for covering. Use the “airfoil
profile” on the fuselage plan set as a guide to
shape leading edge. At wingtip taper leading
edge upward from rib W10 to flow into wing
tip sheeting.
Cover wing using a high quality light weight
covering film. We suggest AeroLITE by
Stevens AeroModel. Note that the plan set
contains a trim guide for the scalloped
covering scheme represented on the product
packaging.
Set the wing aside until final assembly.
QuickOats™ (100)
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
Page 9