stertil-KONI ST 1055, Installation, Operation & Service Manual, Page: 32 / 50

27
FAULT POSSIBLE CASE REMEDY
No mains supply.
Have fault corrected by qualified electrician.
Mains fuse blown. Replace fuse.
Mains switch OFF. Set mains switch ON.
No mains power
(control power
indicator and mains
power indicator are
off)
LEDs faulty. Contact the service department.
Push button indicator
(LED) flashes when
the
⇑
(UP) button is
pressed.
The column has reached the
maximum height.
The column will function normally if the
⇓
(DOWN) button
is pressed.
8.3 IDENTIFICATION
The lifting system has an identification label, a typical label is shown below.
The label is located on the left side of the lifting column, above the control box.
9. LIST OF PARTS AND APPENDICES
9.1 PARTS LIST
The titles of the columns on the parts list mean the following:
Index The numbers in this column refer to the numbers in the parts drawing.
Reference The numbers in this column are STERTIL-KONI order numbers.
Please give these numbers when ordering.
Description This column gives the names of the parts.
9.2 ORDERING SPARE PARTS
Replacement parts can be ordered from Stertil, for addresses see §1.1.
The following information should be given when ordering spare parts:
Type of lifting system : ST 1055 - ST 1060 - ST1072
Serial number : see preceding or type plate on lifting column.
Reference nr. : see fig. A t/m L.