12
SETTINGS ADJUSTMENT
Adjusting the sensor range with the remote control
Tubular was supplied with Stern’s new Self Adjusting Sensor. The ideal sensor
range for the specific location will be set automatically.
Only if necessary
, use the remote control to adjust the sensor range as
follows:
Shut off the water supply. In order to adjust the sensor with the remote control
hold the remote control straight in front of the sensor in a distance of about
4” (10cm). Choose the function you want to adjust by pressing once on one of
the function buttons. After pressing once on a specific function button, a quick
flashing of the red light at the front of the sensor will occur. At this stage, you
can change the adjustment by pressing the (+) or the (-) buttons, every push
will increase or decrease one level. After finishing the adjustment, turn on the
water supply.
Range:
Press + to increase detection range and –
to decrease the detection range of the sensor.
Adjusting other settings with the remote control
Flow time (Security time):
Press + to increase the
security time and – to decrease it.
Delay In:
Changes the time the water will start
flowing when the user’s hands are within the
sensor range. Press + to increase it and – to
decrease it.
Delay Out:
Changes the time of water flow after the user’s hands are removed.
Press + to increase it and – to decrease it.
On/Off:
Press this function button and the faucet will remain off for 1 minute. To
cancel this function press the on/off again.
Reset:
This function allows to come back to all the factory settings. Press the
Reset button and without releasing it, press one time the + button.
Note:
After the reset function is performed, the Self Adjusting Sensor will set
again the ideal sensor range for the specific location. Check that there are
no objects in front of the sensor and wait 10 seconds in order the product
will be ready for use.
