Stern Pinball
Iron Man
Backbox Arc Reactor Flasher Kit
Instructions:
5
9
11
12
10
19) Place the template from the kit directly below
the metal plate holding the CPU and
PDB in the backbox and all the way to the
side of the cabinet.
See
Picture 10.
20) Use tape to attach the template.
21) Locate the
#6 screws
from the kit. Put
one screw in the nut driver and feed it
through the base of the
bracket and
lamp assembly
as shown in
Picture 11.
22) Line up the bracket and lamp assembly
with the left edge of the template right
beneth the metal plate holding the
boards in. See
Picture 12.
23) Install screw into the bracket. Be sure that the
bracket is lined up with the template
before proceeding! Do not tighten the
screw all the way, it should be snug only.
24) Make sure the bracket is flush to the
metal plate holding the CPU and
Power Dirver board. Once confirmed,
install the remaining screw.
25) Remove the template.
27) Install the lamp into the socket.
28) Install the
BLACK wire
from the lamp
socket into the red splice on the
JP6
connector. See picture 1, Page 1.
29) Plug the
RED wire
from the lamp socket
into the blue splice on the
JP7 connector.
30) Wire manage as needed.
Your install is now complete!