Stern Pinball
Iron Man
Backbox Arc Reactor Flasher Kit
Instructions:
4
5
7
8
6
12) Locate the connector labeled
J7 Low Current
Solenoid.
It will be in the middle
bottom of the power driver board.
Picture 6
shows this connector.
13) Locate the
violet wire with the white stripe
on the
J7 connector
. It is in
position 6
,
which is the
5th wire from the left
of the
connector.
* Note:
These connectors are labeled
with the lower numbers on the right of
the connector.
14) Take the
RED
Splice from the kit.
15) Using your thumbs, push the wire into the
metal part of the splice as shown. It will
only just begin to seat, this is just to
keep the wire from moving.
This is shown in
Picture 7.
16) Close the splice around the wire.
Be sure that the wire is in the center of
the metal clip as shown in
Picture
8 to
the left.
* Note:
Failure to watch this step carefully can
cause you to CUT the wire you are splicing!
17) Once you are sure the wire is in the
correct locations in the crimp, grab it by
the thin end as shown in
Picture 8.
18) Grab the closed end of the splice with the
pliers on it's fat end as shown in
Picture 9, Page 5.
Check one more time! Is the wire in the
right location in the splice? If so, squeeze the
pliers until you hear a click.
