12
13
BATTERY REPLACEMENT
Battery models only
When the battery weakens, the red indicator light will blink at a constant rate when the
user’s hands are within the sensor range. The battery must be replaced within two weeks.
To replace the battery in battery models:
1. Carefully open the battery box, use a 2.5 mm Allen key
2. Remove the old batteries
3. Replace the used batteries with new D batteries
4. Close the box.
NOTE:
Do not mix used batteries with new ones.
IMPORTANT:
Spent batteries should not be disposed of with normal
household waste. Contact your local authority for information on waste
disposal and recycling.
REMOTE CONTROL FUNCTIONS
If you acquired the remote control together with your soap dispenser, you may adjust
the dispenser settings if required. To use the remote control hold it straight in front of
the sensor at a distance of about 10-15 cm (4-6”).
Attention: The remote control held out of the recommended range (too close or too far)
will not operate.
The remote control can be used to adjust the following functions:
1-SOAP QUANTITY
The 1-4 drop keys allow the user to choose the desired soap quantity.
*
4
2.1 to 2.3
3
1.6 to 1.9
2
1.2 to 1.6
1
0.7 to 0.9
Indication: continuous blinking of the LED in the sensor eye.
*The exact dosage depends on soap viscosity.
2
3
1
4
2-ADJ
This function resets the sensor back to factory
settings.
Indication: 2 blinks of the LED in the sensor eye.
3-TEMPORARY OFF FUNCTION
This function is ideal to perform any kind of activity
in front of the sensor without operating the system
(for example, cleaning). The soap dispenser will
remain shut for one minute when this button is
pressed once.
To cancel this function and to return to normal
operation press the On/Off button again or wait for
one minute.
Indication: OFF – 2 fast blinks, ON – 4 fast blinks
4-FILL THE SOAP TANk
Once the soap tank has been filled / re-filled, press
the FILL button. The pump will run for one minute
for priming the soap to the soap dispenser spout.
To stop this activity press the FILL button again. If
the soap has not started coming out of the spout,
press the Fill button again.