8
9
INSTALLATION
IMPORTANT:
the 4 contacts connector should be connected properly so that the white
o-ring is not visible and a clicking sound is heard.
PAY ATTENTION:
If the 4 contacts connectors will not be connected properly, the pump
will work continuously.
2a
For battery versions:
install the
battery box on the wall underneath
the sink and connect the battery
connector
FroM the Soap
diSpenSer
to the batterY box
3b
For transformer versions:
plug the
transformer into the electricity
socket and connect the transformer
connector
FroM the tranSForMer
to the Soap diSpenSer
3
Wait about 10 seconds before
you put your hands within the
sensor range to avoid entering the
adjustment mode.
10
SECONDS
ABOUT
EXTREME CS SD B / E
INSTALLATION
STEP 1 – INSTALLINg THE EXTREME CS SD 2030B / E
1
Cut an adequate opening in the wall for
the dimensions of the soap dispenser
base (where you want to install the
spout) and the corrugated tube.
Disconnect the soap dispenser body with
the rosette from the base.
2
Install the faucet base firmly to the
roughing wall and secure it using
the two anchors provided in the package.
NOTE: Make sure that the corrugated tube outlet remains outside of the wall during
tiling. Access is needed after the completion of the wall.
3
Once the works on electricity,
plumbing and tiles have been
finished, insert the wall rosette
through the soap dispenser
base.
Fix the soap dispenser spout by
inserting the nipple into the soap
dispenser base.
Pull the four contacts connector and the
power supply connector out of the soap
dispenser base, and lead them through
the corrugated tube.
EXTREME CS SD 2030B / E