6
I N S TA L L AT I O N
NARA 2032
Step 1 – Installing the flush valve and connecting the water supply
1) Shut off the water supply.
2) Cut an adequate opening in the wall for the dimensions
of the box and the sleeve (not supplied).
3) Insert the electronic flush valve’s box through the
opening.
4) Connect the flush valve inlet to the water supply.
5) Connect the flush valve outlet nipple to the pipe
leading to the W.C.’s inlet.
6) Turn on the water supply. Make sure there is no water
leakage.
7) Assemble the temporary protective cover to protect the flush valve.
Step 2 – Connecting the power source
1) Once the electricity, plumbing and tiles works are
finished, replace the temporary protective cover
with the plastic seat. Adjust it using the four screws
provided.
2) a. Connect the electronic unit connector that leads
to the solenoid valve to the solenoid connector.
b. Connect the electronic unit connector that leads
to the power source to the battery box connector.
3) Before assembling the panel, consider using
the provided adjusting screw in order to optimize
the operation of the mechanical button. If needed,
assemble the adjusting screw to the mechanical button at the internal side
of the panel and adjust it to the desired distance.
