9
NARA 2032 E
INSTALLATION
10) Wait about 30 seconds before you step or put your hand within the sensor
range. As an indication that the self adjusting is taking place, a red light in the
sensor eye will flash continuously. The solenoid valve will be opened and closed
for 1 second as an indication that the ideal sensor range was set and the product is
ready for use.
11) To operate, step within the sensor range for a minimum of 8 seconds.
Move away and the flush valve will flush a few seconds after your departure.
12) If needed adjust the flow rate by turning the regulating valve. In order
to avoid entering into the self adjusting mode, do not disconnect the cables
between the electronic unit and the transformer.
13) If the range is unsatisfactory, refer to the section entitled “Settings
Adjustment”.
6) Assemble the panel to the cover seat and
tighten it with the bottom screw.
7)
The ideal sensor range for the specific location
will be set automatically. Right now, check that no
objects are in front of the sensor.
8) Remove the protective sticker covering the sensor
.
9) Plug in the transformer
.
Keep away from the sensor range.
