12
13
FILLING THE SOAP TANK
SETTINGS ADJUSTMENT - SOAP DISPENSER
1
Unscrew the soap tank from the pump assembly and
pull it out of the bottle support.
2
Fill in the liquid soap up to the top lin
e.
3
Insert the bottle inside the bottle support.
4
Screw the soap tank back to the pump assembly. Make
sure the tank is firmly secured into place.
5
Press the refill button located at the back of the pump
assembly until soap starts coming out of the soap
dispenser spout. This operation can also be done
using the soap dispenser remote control Refill function.
6
NOTE
: Once the soap in the soap tank has reached the
bottom line the soap tank should be refilled. To refill
the soap tank please refer to steps 1-5.
If you acquired the remote control together with your soap dispenser, you may adjust
the dispenser settings if required. To use the remote control hold it straight in front
of the sensor at a distance of about 10-15 cm (4-6”).
Attention: The remote control held out of the recommended range (too close or too
far) will not operate.
The remote control can be used to adjust the following functions:
1-SOAP QUANTITY
The 1-4 drop keys allow the user to choose the desired soap quantity.
4
2.1 to 2.3 *
3
1.6 to 1.9
2
1.2 to 1.6
1
0.7 to 0.9
Indication: continuous blinking of the LED light in the sensor eye.
2
3
1
4
2-ADJ
This function resets the sensor back to factory
settings.
Indication: 2 blinks of the LED light in the sensor
eye.
3-TEMPORARY OFF FUNCTION
This function is ideal to perform any kind of
activity in front of the sensor without operating
the system (for example, cleaning). The soap
dispenser will remain shut for one minute when
this button is pressed once.
To cancel this function and to return to normal
operation press the On/Off button again or wait
for one minute.
Indication: OFF – 2 fast blinks, ON – 4 fast blinks
4-FILL THE SOAP TANK
Once the soap tank has been filled / re-filled,
press the FILL button. The pump will run for
one minute for priming the soap to the soap
dispenser spout.
To stop this activity press the FILL button again.
If the soap has not started coming out of the
spout, press the Fill button again.
