3.5.3. Entering hopper values
Select
”Hopper”
.
Acknowledge with the ENTER-key.
or
Press the
”F4”
-key.
Hopper entry X Target
(X = number of the drying hopper)
Enter the drying temperature for hopper flap X (when operating with supplementary heating).
Acknowledge with the ENTER-key.
Hopper entry X Act.
(X = number of the drying hopper)
The current temperature at the feed opening of hopper flap X will be displayed.
&
If there is a ca ble break “+0 °C” (32°F) is dis played.
F
The lowest drying temperature setting of the hopper flap must be the
same as or higher than the drying temperature.
Press the “
â
” key.
0
2
6-
2
M
S
STT 500
Start-up 3-11
Summary of Contents for Sterling Dehumidifier STT 500
Page 71: ...0 2 6 2 M S STT 500 Technical Data 9 2 All dimensions are in mm in Subject to alteration...
Page 72: ...Dimension sheet 0 2 6 2 M S STT 500 Technical Data 9 3...
Page 80: ...Accessories Entering values on the OP 7 17 Sterling Material Processing B G 1 0 2 0...
Page 86: ...Accessories Flap control with Fuzzy Logic Sterling Material Processing B G 0 0 0 1...
