Document # 82070-637, Revision D
CONFIDENTIAL
© 2009 Copyright VTS Medical Systems, LLC
7 of 29
Mounting the Monitor
The monitor can be mounted using the eight included screws. The hole pattern for the eight screws needed to mount
the monitor can be seen in the drawing below.
Unscrew the eight screws from the back cover. It is recommended that you use all eight screws when mounting the
monitor using a wall mount kit (not included). You must use at least four of the screws, either in the four center holes
or the four outer holes. Follow the directions that come with the wall mount kit to complete the installation.
Figure 2: Mounting Holes
Connecting the Video Inputs
The video input cable(s) should be attached to the appropriately labeled ports on the back of the monitor as shown
below. The following inputs are available:
Name
Connection Type
VGA (RGB) input
D-Sub 15pin (x1)
DVI input
DVI-D (x1)
Y/Cb/Cr input
8pin Mini Din (x1)
S-Video input
4pin Mini Din (x1)
Video Input
RCA Jack (x1)
HD-SDI input (Option)
BNC Connector (x3)
RGBSync input (Option)
BNC Connector (x8)
RS-232 control (IN/OUT)
D-Sub 9 pin
USB Touch Control( MON-STE42SDI-MT / MON-STE52SDI-MT only)
USB-A
RS-232 Serial Touch Control (MON-STE42SDI-MT / MON-STE52SDI-MT only)
D-Sub 9 pin
AC Switch / Power cord input
AC Power Input
Table 1: Inputs and Connections
Figure 3: Connecting the Power Cord
Eight mounting
holes and screws
These ports available on MON-STE42SDI-MT /
MON-STE52SDI-MT only
