Document #
Revision Date
82070-243, Revision F
6 of 22
11/24/2009
Connecting the Monitor and Turning On/Off
Step 1: Unpacking the carton
Included in the carton for part numbers MON-STE19HD, MON-STE19HDM, MON-STE21HD and MON-
STE21HDM are the following items:
1 VividImage
®
HD Monitor
1 Cable Cover (screwed onto the back of the monitor)
1 Power Cord
1 Power Supply
8 Mounting Screws (screwed into the back of the monitor)
1 Quick Start Guide
For part numbers MON-STE19HDR, MON-STE19HDMR, MON-STE21HDR and MON-STE21HDMR, there
is not an included Power Supply and Power Cord. (See Step 4, Connecting to Power).
If any one of these items is missing, please call Customer Support at (877) 887-1788.
Step 2: Mounting the monitor
The back of the monitor (see Figure 1) has a hole pattern that complies to the VESA (Video Electronics
Standards Association) mounting standard. The monitor is shipped with eight screws that are screwed into
the back of the monitor. Four screws are ½
″
long and four screws are
⅜″
long. Remove all eight screws
and use one set of four screws to attach the monitor to the mount, either in the inside square hole pattern
(75mm) or the outside square hole pattern (100mm). Use the longer four screws for mounts with thicker
mounting plates. The mount is sold separately.
Note to users attaching the VividImage
®
Monitor to Operating Room Equipment Management System and/or
Equipment Boom:
If the VividImage
®
Monitor is to be mounted on a boom and/or Equipment Management System, the
boom vendor should have wired the appropriate cables through the boom arm.
Step 3: Attaching the monitor to a boom arm and connecting video and power sources
1. Attaching the VividImage
®
monitor to a boom arm requires two (2) people.
2. One person should hold and support the monitor while the second person attaches the monitor to
the boom arm.
3. One person should align the monitor to the mounting holes while a second person physically
attaches the monitor to the VESA mount attached to the boom arm.
4. After the monitor is mounted, remove the cable cover and connect the customer supplied video
cable(s) and power cord, if applicable, to the appropriate port on the back of the monitor. The ports
on the monitor are clearly labeled (see Figure 1). For a photo of possible video sources, see
Figure 2.
5. The cable cover should be re-attached using the included screws.
6. The monitor will turn on automatically once it is connected to a power source.
