Installation/Uncrating Instructions
2-2
122990-172
Uncrating Instructions
3.
Pull out and discard the wooden base under the washer.
4.
Move washer to installation site.
5.
Lower the washer.
6.
If washer is too high to be lifted by forklift, the washer may be
tilted (see Figure 2-3).
a. Place cardboard or removed foam sheets on skid to
protect cabinet.
b. Slowly tip washer sideways and lower onto skid, being
careful to prevent damage.
c. Move unit by forklift to its permanent site.
d. Carefully tip unit back to a standing position.
1.
Remove all tape from washer/disinfector.
2.
With door closed to prevent counterweight from dropping,
remove the door counterweight blocking pin as follows (see
Figure 2-4):
a. Remove bolts holding left (when facing front [soiled] side of
unit) side panel to washer.
b. Remove left side panel.
c. Remove screw from blocking pin. Keep screw.
d. Slide blocking pin out of counterweight box.
e. Once counterweight moves freely, fasten blocking pin
onto outside edge of counterweight box, attaching screw
previously removed through hole provided for pin stor-
age (see Figure 2-4). Pin may be needed for future door
maintenance work.
Figure 2-3. Tilt Washer
Figure 2-3. Tilt Washer
Figure 2-3. Tilt Washer
Figure 2-3. Tilt Washer
Figure 2-3. Tilt Washer
Figure 2-4. Remove Blocking Pin
Figure 2-4. Remove Blocking Pin
Figure 2-4. Remove Blocking Pin
Figure 2-4. Remove Blocking Pin
Figure 2-4. Remove Blocking Pin
1
2
4
Blocking Pin
For Blocking Pin
Storage
Screw
Prepare Washer/
Disinfector for
Installation
12345678901234567890123456789012123456789012345678901234567
12345678901234567890123456789012123456789012345678901234567
12345678901234567890123456789012123456789012345678901234567
12345678901234567890123456789012123456789012345678901234567
12345678901234567890123456789012123456789012345678901234567
12345678901234567890123456789012123456789012345678901234567
CAUTION: Leave door closed to
prevent counterweight from drop-
ping to bottom of guiding box.
WARNING - PERSONAL INJURY
AND/OR EQUIPMENT DAMAGE
HAZARD: To tilt the washer/
disinfector, more than one per-
son is required. Washer/
disinfector weighs approximately
1000 lbs (454 kg).
CAUTION: If unit must be tilted,
tilt unit onto left or right side.
Handles and control panels could
be damaged if unit is tilted onto
front (soiled) or back (clean) side.
