Stensat StenBOT Rover Kit, Manual

Page: 38 / 180

38 38
Motor Preparations
●
The four motors are to be prepared the same.
●
Take two 1 inch screws and insert them from
the white shaft side of the motors.
●
Install a kep-nut on each screw and tighten to
be snug. Do not over tighten as that can
damage the plastic structure of the motors.
●
Prepare all four motors the same.
●
The kep-nuts are installed to offset the motor
from the rocker arm. This allows space for the
wire to be between the motor and the rocker
arm.
●
The tie wrap is used as a strain relief to
protect the wire from breaking off the motor
connection. This also allows the user to easily
make repairs or replace the wiring if desired.
Kep-Nuts
White Wheel Shaft
on Opposite Side