INSSTE302P0514
8
adjustment of the hour and the day
To adjust the hour and the day:
1. In any mode (Manual, Automatic or Prepro grammed), out of any adjustment mode, press down the
button and release it.
2. The current time mode (24H/12H) is displayed. Press down the or button to select the desired
format. Press down the
button to confirm your choice.
3. The two hour digits flash. Adjust the hours using the and buttons. Press down the
button
to confirm your choice.
4. The two minute digits flash. Adjust the minutes using the and buttons. Press down the
button to confirm your choice.
5. The day of the week flashes. Adjust using the and buttons. Press down the
button to
confirm your choice.
The adjustment is thus completed and the thermostat returns to normal operation.
It is possible to exit the hour and day adjustment mode at any time:
• By pressing down the button.
• By not pressing down any buttons during 1 minute.
In case of a power failure lasting less than 2 hours, the thermostat saves the adjustment of the hour and
the day of the week. When the power is restored after an extensive failure, the hour will blink, indicating
that it must be readjusted.
ambient temperature
The figures displayed above the hour indicate the ambient temperature. It can be displayed in degrees
Celsius or Fahrenheit (see “Display in degrees Celsius/Fahrenheit”).
To adjust the set point, out of any adjustment mode, press down the button to increase the set point (it
will blink), or the button to decrease it. Set points can only be adjusted by increments of 0.5°C (1°F).
To quickly scroll through the set point values, press and hold down the button. The minimum set point is
3°C (37°F), and the maximum set point is 30°C (86°F).
To return to the ambient temperature, do not press down any buttons for 3 seconds or press down both
and buttons simultaneously. You can turn off the thermostat by lowering the set point below 3°C
(37°F). The set point value displayed will be --.-, and heating system start up will be impossible.
