33
Commands
The following commands are available on the SP-1.
Command name
Action
!OFF
<CR><LF>
Turns the SP-1 off.
!ON
<CR><LF>
Turns the SP-1 on.
!PWR
<CR><LF>
Toggles power on the SP-1. Same functionality as the standby
button on the front.
!VOLDN
<CR><LF>
Decreases the volume 1 step (0.5 dB).
!VOLUP
<CR><LF>
Increases the volume 1 step (0.5 dB).
!VOLCH(d)
<CR><LF>
Changes the volume by the deltavalue d. An example to turn down
the volume by 3.2 dB:
!VOLCH(-32)
<CR><LF>
Note: This function will handle volume in steps of 0.1 dB!
!VOL(n)
<CR><LF>
Sets the volume to the value n, where n is between -980 and 120.
If n is higher than the maximum volume, volume will be set to the
maximum volume.
Note: This function will round the volume to steps of 0.5 dB.
!MUTEON
<CR><LF>
Mutes the SP-1.
!MUTEOFF
<CR><LF>
Demutes the SP-1.
!MUTE
<CR><LF>
Toggles mute.
!MAXVOL(n)
<CR><LF>
Sets the maximum volume to n, where n is between -600 and 120.
If the maximum volume requested is less than the default volume
of the system, the maximum volume will be set to the default
volume.
!DEFVOL(n)
<CR><LF>
Sets the default volume to n, where n is between -980 and the
current value of the maximum volume.
!SRCDN
<CR><LF>
Selects the previous enabled input source. Same functionality as
rotating the input selector on the front counter clockwise.
!SRCUP
<CR><LF>
Selects the next enabled input source. Same functionality as
rotating the input selector on the front clockwise.
!SRC(n)
<CR><LF>
Selects the source n if it is enabled. For valid values of n refer to
Input Source Numbering on page
Fejl! Bogmærke er ikke
defineret.
.
!SRCALL(n)
<CR><LF>
Selects the source n even if it is not enabled. For valid values of n
refer to Input Source Numbering on page
Fejl! Bogmærke er ikke
defineret.
.
