12
measuring device. Before starting, place the RoomPerfect™ microphone at listening height
in the main listening position. For each channel, measure the straight-line distance through
the air from the tip of the RoomPerfect™ microphone to the center of the tweeter unit in the
loudspeaker in question. When measuring distances to boundary woofers, measure the
distance to the top back edge of the woofer. If in doubt, contact your Steinway Lyngdorf
representative for guidance.
Do not measure distances at floor level, as these measurements will not give acoustically
accurate results.
Setup / RoomPerfect™
Enter the Guided Setup for doing a RoomPerfect™ calibration. See RoomPerfect™ section
on next page for a guide to setting up RoomPerfect™.
Setup / Input Name
Enter a unique reference for the source connected to the input selected. To select the letters,
use the buttons on the remote to scroll through the alphabet. Press enter to select the letter.
After completing the name, select the END character at the bottom of list. Press OK to store
the name.
Setup / Input Enable
Select DISABLE for all the inputs not connected to sources and the sources will be removed
from the selectable list.
Setup / Input Sensitivity
Adjust the sensitivity from 0 to +24dB for the selected source to be at uniform level. Note:
This is not volume-gain, it is volume-offset. For example, if an input is set to +12dB then the
maximum volume for that input will be 87.9 on the SP-1 display. Going beyond 87.9 will
increase the number on the display but not the volume.
Setup / Voicing
Select one voicing to be a default when the unit is turned on or select “Store Previous
Voicing” to have the same voicing when powered on as when the SP-1 Stereo Processor is
powered off. See page 23 for an overview of the voicing curves.
Setup / Volume / Maximum Volume
Set the maximum volume for daily volume control.
Setup / Volume / Default Volume
Set the default volume when you power on.
