3.
Adjust the sensitivity. Press the SENS button, then press the "+" or "-" button
to increase or decrease the sensitivity.
The sensitivity level will be displayed on the LCD. The unit defaults to a
sensitivity level of 6/8.
To find objects deep in the ground, the sensitivity must be higher. If the
sensitivity is set to the highest limit, it is possible that the detector will emit
false signals.
PLEASE NOTE: if the SENS, "+", "-" button is not pressed within 2 seconds, the
unit will go into standby mode.
4.
Place the detector on a wooden or plastic table, and then the user should
remove any watches, rings, or metal jewelry the user is wearing.
5.
Position the probe so that the flat part of the probe is facing the ceiling.
CAUTION!
Do not test the detector on the floor inside a building. Most
buildings have metals embedded in the floor that can interfere with or completely
mask the signal.
6.
Slowly move a sample of the material you want the detector to find (e.g. gold
ring, coin) a few centimeters above the probe surface. When the detector
detects metal, it will beep and the target icon will flash. The LCD display will
also show the reading value and the depth at which the target was detected.
Note that the depth is only a reference point.
CAUTION!
The detector will detect a coin more easily if it is held with its flat
side parallel to the probe. Moving the coin sideways may cause false readings and
unstable readings.
OPERATING THE UNIT OUTDOORS
1.
To turn on the unit, gently turn the knob clockwise.
2.
Set the desired operating mode (see "OPERATING THE UNIT INDOORS", section
2).
