Steinbach 061023, Original Owner'S Manual

Page: 42 / 308

Fault description Cause Remedy
1H+2H+3H blink rapidly and a
buzzing sound is heard Seal of the motor unit is not leak-
tight. Stop the device and contact
customer service.
ALL+1H blink rapidly and an alarm
is heard Pump is overloaded. Stop the device and check the wheel
and the pump.
WALL+2H blink rapidly and a
buzzing sound is heard Drive motor 1 is overloaded. Check the drive belt.
FLOOR+3H blink rapidly and a
buzzing sound is heard Drive motor 2 is overloaded. Check the drive belt.
ALL+WALL+1H+2H blink rapidly and
an alarm is heard There is abnormal voltage in the
device. Stop the device and contact
customer service.
WALL+FLOOR+2H+3H blink rapidly
and a buzzing sound is heard Device is out of the water. Stop the device, immerse it in water
and start the device again.
WALL+FLOOR+2H+3H blink rapidly
and an alarm is heard Device is out of the water and could
not be restarted. Stop the device, immerse it in water
and start the device again.
WALL blinks rapidly and an alarm is
heard Device has toppled over. Manually set the device straight
again.
The cable is twisted or tangled. The cable was not completely
detached. Switch off the device, disconnect the
cable and untangle it.
The cable in the water is too long. Pull the excess cable length out of
the water. The cable in the water
should only be long enough so that
the device can reach all spots in the
pool.
The device becomes stuck on the
drain grate. Switch off the filter system of the
pool.
The device cannot reach all spots. The control unit was wrongly
positioned. Position the control unit so that the
device can easily access all spots.
The water circulation of the pool is
switched on. Switch off the filter system of the
pool.
The cable is too short. Let a sufficient length of cable into
the pool so that the device can
reach all spots in the pool. Observe
the minimum distance of the control
unit to the pool.
42