Steinbach 061023, Original Owner'S Manual

Page: 38 / 308

2. Connect the plug of the floating cable
7
in
the right position to the control unit
3
and
screw the connection together.
3. Attach the control unit
3
at a distance of at
least A=3.5 m to the pool with the safety rope
6
so that it cannot be pulled into the water.
4. Connect the power plug to a grounded socket.
The control unit is connected.
Starting cleaning
1. Press the ON/OFF button on the control unit.
The display indicates the settings of the last selected cleaning program.
2. Select the desired type of cleaning and adapt the running time to the size of your pool.
3. Press the ON/OFF button again to start the set cleaning program.
Cleaning starts and the running time LED starts to blink.
Connecting the app to the device
1. Activate Bluetooth.
If you use an android device, you might have to activate GPS as well.
2. Start the "Steinbach APPcontrol" app.
3. Start the device detection.
4. Tip on the displayed device to connect it to the app.
Once the connection has been successfully established, the connection status indicates
"connected".
The app is connected to the device.
Switching off the device
Proceed as follows to switch off the device:
1. Switch off the device after the end of the cleaning program.
2. Disconnect the control unit from the power supply and the device.
3. Lift the device out of the pool.
4. Clean the filter units and the device.
5. If you use the autostart function, place the device in the pool again and connect the control unit to
the power supply.
8
7
3
9
A
3 6
38