EN
Espire Elleboog Pro & Hybrid van Steeper Group, distributeur Loth Fabenim B.V.
Espire
TM
Elbow Pro & Hybrid Instruction Manual - For Prosthetists
41
8.5 Ottobock 10S17 Electronic Wrist Rotator Installation
Lamination Ring
Bond the lamination ring into the forearm of the Espire Elbow
before installing the electronic wrist rotator.
Refer to the manufacturer’s instructions for more detailed
fabrication and assembly information.
Wrist Installation
8
Wiring
Connector Orientation - The curve of the socket connectors should face inward
toward the centre of the wrist; however, the 2-socket wrist connector is reversible.
1.
Insert the orange (handopen) cable into the left
pins labeled “2”.
2.
Insert the green (hand-close) cable into the
right pins labeled “2”.
3. Insert the factory provided motor connection
into the left pins labeled “3”.
4.
Insert the grey (wrist) cable into the right pins
labeled “3”.
5.
Insert the red (power) cable into the left pins
labeled “1”.
Caution: Do not insert the 2-socket connectors (wrist, power, or motor) into the
wrong pin receptacles. This may damage the hand or Espire system.
Note: If the 3-socket connectors (hand-open/hand-close) are attached to the wrong
pin receptacles labeled “2”, the open-close functions will operate in reverse.
1
1
2
3
3
2