Torch Runner (HS)
Torch Runner (HS) Operator’s Manual
12
3.4. Troubleshooting
Message
Problem
Solution
Not all display segments lit after
powering indicate a problem with the
display or controller.
Contact service center for inspection
and repair.
Speed displayed in centimeters per
minute instead of inches per minute.
Follow instructions given in the
section “Changing the unit of speed.”
Speed displayed in inches per minute
instead of centimeters per minute.
Follow instructions given in the
section “Changing the unit of speed.”
1. Travel direction switch not set to
‘O’
when powering.
2. Displayed during travel indicates
a malfunction of the travel direction
switch or travel direction identification
circuit of the controller.
1. Set the travel direction switch to
‘O’. If the message still appears,
contact service center for inspection
and repair.
2. Contact service center for
inspection and repair.
Motor overload (safe current level
exceeded) that promptly stops the
carriage.
Adjust the arrangement of the cables
that block the travel and remove any
other elements that block the carriage
or its wheels.
If this message still appears, contact
service center for inspection and
repair.
