SM-WC-
LR Li’l Runner (HS)
Li’l Runner (HS) Operator’s Manual
14
3.6. Troubleshooting
Message
Problem
Solution
Display not fully on after powering.
Contact service center for check
and repair.
Speed shown in centimeters per
minute instead of inches per minute.
Refer to the section “Changing the
unit of speed.”
Speed shown in inches per minute
instead of centimeters per minute.
Refer to the section “Changing the
unit of speed.”
Travel direction switch not set to ‘O’
when powering.
Set the travel direction switch to ‘O’. If
the message still shows, contact
service center for check and repair.
Shown during travel indicates
a malfunction.
Contact service center for check and
repair.
Motor overload. The carriage stops.
Use the welding cables whose weight
is not more than the maximum weight
specified in the technical data.
Adjust the position of the cables so
that they do not block the carriage.
Remove other objects that block the
carriage or its wheels.
If this message still shows, contact
service center for check and repair.
Summary of Contents for Li'l Runner
