ST1007/12/14 15" & 20" Planers (Mfd. Since 3/16)
-19-
The cast-iron extension wings are identical for both
the infeed and the outfeed ends of the table.
To assemble planer:
1. Clean the wing, table, wing mating surfaces, and
wipe a thin film of oil on the surfaces.
2. Loosen the table-roller set screws and turn the
eccentrics until the table rollers fall below the
table surface. Refer to Figure 12 for locations.
Figure 13. Extension wing installed.
Set Screw
Hex Bolt
Figure 12. Table roller adjustment locations.
Table Roller
Set Screw
Eccentric
3. Install (2) M8-1.25 x 20 set screws into each
wing. Refer to Figure 13 for location.
4. With a helper, match the tapped holes on the
side of the table to the cast iron wings and
lightly secure the wings in place with the (3)
M8-1.25 x 30 hex bolts and the 8mm lock and
flat washers (for the ST1014 use (3) M8-1.25 x 35
hex bolts).
5. Place a straightedge flat across the table and
across the wings, as shown in Figure 14.
Figure 14. Setting wing height.
6. Adjust the M8-1.25 x 20 set screws so the wings
are flush with the table.
7. Tighten the hex bolts to secure the wings in
place. The top of the wings should now be
completely even with the top of the table, but
double-check to make sure that the wings did
not move during the tightening process.
8. Treat the wing and table top surface with an
anti-rust compound or light machine oil to pre-
vent rust.
Note:
If this is a first-time setup, DO NOT adjust the
table rollers yet, you will do this adjustment later.
Assembly
