-6-
ST1007/12/14 15" & 20" Planers (Mfd. Since 3/16)
F. Return Rollers: Assist sliding workpiece back to
operator following planing operation.
G. Dust Port: Connects to a dust collection system
to extract shavings and dust during operation.
Figure 2. Return rollers and dust port.
G
F
Figure 3. Mobile-base foot pedal.
H
H. Mobile-Base Foot Pedal: When engaged, lifts
machine onto casters for repositioning. When
disengaged, allows machine to rest firmly on
floor during operations.
Refer to the Figures 1-3 and the following descrip-
tions to become familiar with the basic controls and
components of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and stay safe when operating
this machine.
A. Control Panel for Magnetic Switch: Green
START button turns motor ON when pressed.
Red Emergency STOP button turns motor OFF
when pressed; for safety purposes, this button
will remain depressed and prevent restarting
until reset. Reset by rotating clockwise until it
pops out.
B. Table Height Handwheel: Raises and lowers
table to accommodate different workpiece
thicknesses. One complete revolution moves
the table approximately
1
⁄
16
".
C. Feed Rate Control Knob: Selects 30 FPM feed
rate when pushed in, and 16 FPM feed rate
when pulled out.
D. Table Locks: Secure table height position when
tightened.
E. Depth-of-Cut Limiter: Limits depth of cut to a
maximum of
1
⁄
8
" at full width.
Figure 1. Table elevation and feed controls.
A
B
C
D
E
To reduce your risk of
serious injury, read this
entire manual BEFORE using
machine.
CONTROLS & COMPONENTS
