Page 14 of 38
939564909 Rev B
®
1
Locate the two (2) pilot holes for mounting the
1
Installing Switch & Power Supply
Fit the keyhole slots of the power supply over
2
the screws, and slide over into place.
power supply. Partially install two (2) #8-15 x 5/8"
Attach the switch at the front of the worksurface,
3
adjacent to the leg with the master motor. Use
the pre-drilled pilot holes for proper switch position,
screws per the diagram shown below.
NOTE:
Use the pre-drilled pilot holes to mount
the power supply in a way that assures
accessories can be clamped to the
worksurface, and allow all cables to reach.
If a different power supply location is desired,
use the template below, which matches the
the power supply's keyhole slots and 122mm
hole spacing.
and affix with two (2) #8-15 x 5/8" screws.
< 1 2 2 m m >
P o w e r S u p p l y Te m p l a t e
2 x
Ø4mm
4mm
Template for Power Supply:
POWER SUPPLY
NOTE:
Assemblies with a Nexsis Power Access
Door Package require the Power Supply to be
installed at an alternate location as shown.
Series 5 Table Assembly (cont.)
2
SWITCH
MASTER MOTOR
