Page 12 of 38
939564909 Rev B
®
Insert hex shafts into driveshaft tube.
6a
Installing Driveshafts (cont.)
6b
Series 5 Table Assembly (cont.)
6b
If the hexagon openings are not perfectly aligned,
rotate the motor up and down to align the hex
shaft with the driveshaft tube, until the driveshaft
slides through with ease.
6c
Ensure all driveshafts are inserted into driveshaft
tubes. Tighten set screws very tightly with
a 3mm hex wrench.
6c
NOTE:
DO NOT
overtighten the set screws.
Overtightening can strip the threads in the
driveshaft tube.
NOTE:
DO NOT
pound the hex shafts through with a
hammer. This will mushroom the end of the hex shaft.
6a
