Page 11 of 12
939599284 Rev D
®
4
3.
Route cable through VIA mount cover and mount.
Secure cable to cable retainer clip.
4.
Engage cover spur into mount and pivot to align
mounting holes. Route cable through opening in mount.
NOTE:
Adhesive pad must adhere directly to glass.
5
.
If desired mounting location has vinyl film applied to glass,
carefully cut a 76 mm diameter circle through the vinyl with
an X’acto type blade. Remove the film from cutout area. Clean
the exposed glass surface with an alcohol pad.
6.
Remove film backing from adhesive pad. Locate alignment
tabs against edge of glass frame and press VIA mount onto
glass. VIA Mount will be centered at 51-1/4” H.
7.
Position tab of wall bracket at top and fasten bracket to
mount with (4) fasteners.
8.
Remove film backing and affix back cover plate to
opposite of glass. Refer to Room Wizard II Installation
Quick Start Guide
for remaining assembly.
9.
Reinstall interior glass frame and lock in place
using lock rods.
INSTALLATION OF VIA GLASS MOUNT
CABLE RETAINER
CLIP
COVER SPUR
3
5
7
BACK COVER
PLATE
COVER SPUR
Extra cable can be managed
by filling openings.
MOUNT BRACKET
TAB
WALL BRACKET
TAB
6
TOP VIEW
