steel I7C-2, Instruction Manual

Page: 12 / 28

Installation
Preliminary operations
The barbecue has been designed and built to cook and heat food in
the open air. This appliance is not designed for use in a professional
setting or in enclosed spaces.
Before installing and using the barbecue, the interior should be
cleaned of any manufacturing residue. For further information on
cleaning referto chapter "Cleaning the barbecue" on page 12.
Choose the installation site for the barbecue carefully:
1. it must not be too dusty: long term dust may clog the
burners and make using the barbecue hazardous;
2. it must not be too exposed to the wind: during use strong
winds may prevent the barbecue from working properly or
accidentally switch off the burners;
3. position the barbecue so that it is completely stable;
4. away from inflammable materials.
Before installing and using the barbecue remove all plastic transit
protections from the control panel and from the stainless steel
sides of the appliance.
Connecting the gas bottle (category II2H3+)
The appliance is already regulated to operate with LPG (G30/31 at
28-30/37mbar). Simply connect the rubber pipe using the seals and
clamps supplied as described below.

Remove the lower rear panel "F": pull it up and ahead.

Remove the upper rear panel "G": pull it up and ahead.

Provide a gas pipe of 800 mm length. You may need a pipe
holder "H" on the end of the ramp "E".

Connect the end "A" of the gas pipe directly to the ramp "E"
or to the pipe holder "H".

Connect the end "I" of the gas pipe to the pressure
regulator "C".

Connect the gas pressure regulator "C" to the threaded
union "B" on the bottle.

When the gas bottle is inside the chart make the gas tube
going trough the hole "D" then connect.

Fit the rear panels "G" and "F" putting in position then
pulling down.
The symbols in the picture mean that on those points a
clamp could be necessary.
After connecting, ensure the rubber pipe is not crushed, hanging
or obstructing the hole in the lid.
Contact your nearest authorised service centre to connect
the barbecue to a methane supply (G20 at 20 mbar).
Refer to current regulations to fit or replace the rubber pipe.
The pipe's expiry date is printed on the pipe itself. Ensure the
pipe is replaced before this date.
Should the gas bottle not be fitted with a stop valve, a shut-off tap
should be used. The tap must be easily accessible.
Do not obstruct the vents in the bottle compartment. The gas bottle must
be replaced away from any power source.
B
C I A H
G
F
E
D