Power Input
Plug the Power
Plug Pack into a
power point.
Optional:
If your motor has
24V terminals they
can be used instead
if necessary.
Quick Connector wiring
Photo Eye Beams PEB1 /
PEB2
It is recommended that PE Beams
are used for safety.
Note:
Only wire to the garage
controller if your motor does not
have PEB terminals. Otherwise it is
recommended that the PE Beams
remain connected to your motor.
PEB 1
PEB 2
Motor 1
Power
Door 1
Door 2
Motor 2
Quick Connector
Garage Controller
The quick connector plugs into the
controller to make wiring easier.
Door Motor 1 /
Motor 2
The M1 wires should be connected to the
Push Button
(Bell Press)
terminals of the Garage Door Motor.
M2 wires are for Garage Door Motor 2.
Note:
Please refer to your garage door motor manual or
the following pages for some common motor types.
Garage Controller
can control
up to two doors motors.
An additional
Sensor
is
required for the second door.
Example shown with roller doors.
Typical 2 door garage.
Motor 1
Motor 2
Sensor 1
PEB 1
PEB 2
Sensor 2
Door 1
Door 2
