Steel City 45925C, User Manual

Page: 23 / 44

23
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
N
Q
Fig. 24
Fig. 26
Fig. 27
Fig. 25
1. Remove the hex nut (K) and outer flange (J) from the
blade arbor (I).
NOTE: The arbor has a right hand thread; to loosen the
hex nut turn it counterclockwise by using the supplied
wrenches.
2. Place a 10” saw blade (Z) onto the blade arbor (I),
make sure the teeth of the blade are pointing down in
the front of the table saw. Place the outer flange (J)
and hex nut (K) onto the blade arbor and snug hex nut
by hand. Place the open-end blade wrench (L) on the
flats of the inner blade flange (not shown) and the
box-end blade wrench (M) onto the hex nut and
securely
tighten. SEE FIG. 23
NOTE: The blade arbor has a right hand thread, to
tighten the hex nut turn it clockwise.
\
3. Place a square (N) onto the saw blade and against the
splitter assembly (O). Make sure the splitter is square
to
table. SEE FIG.24
4. Lay a straight edge (R) against the left side of the saw
blade (S) Align the splitter and make sure the splitter is
aligned to the blade.
SEE FIG.25
CONVERSION THE SPLITTER TO
RIVING KNIFE
NOTE: Splitter can be used as riving knife.
1. Remove the guard assembly(C) and kick-back pawl
assembly (D) by loosing knob (A) and (B).
SEE FIG. 26
2. Remove the table insert (E). SEE FIG. 26
3. Loose Fasten Knob (B) and locate pin to hole (A).
SEE FIG. 27
4. Tighten the Knob (B) and re-install the table insert.
SEE FIG. 27
A
C
E
A
B
D
B
R
S
T