Steel City 35920, User Manual

Page: 13 / 38

• The table saw is a heavy machine; two people may be
required for certain assembly operations.
• DO NOT assemble the table saw until you are sure the
tool is unplugged.
• DO NOT assemble the table saw until you are sure the
power switch is in the "OFF" position.
• For your own safety, DO NOT connect the machine to
the power source until the machine is completely
assembled and you read and understand this entire
User Manual.
INSTALLATION AND LEVELING
Final location for the saw must be level, dry, well lighted,
and have enough room to allow movement around the
saw with long pieces of wood stock.
Level the saw front to back and side to side. If necessary,
but make sure the saw is stable before being placed in to
service.
DUST PORT ASSEMBLY
Fig. 1
1. Attach the dust port to the opening in the bottom rear
of the cabinet with four 1/4-20x1/2"
SEE FIG.1.
HANDWHEEL ASSEMBLY
Fig. 2
A
B
C
1. Place one of the handwheels (A) onto the blade
raise/lower shaft (B) located on the front of the
cabinet. Align the groove in the back of the
handwheel with the pin (C).
SEE FIG 2.
Fig. 3
D
2. Thread the locking knob (D) onto the threaded end of
the shaft.
3. Repeat the steps above to assemble the remaining
handwheel and locking knob onto the bevel shaft
located on the side of the cabinet.
SEE FIG 3.
17