Steel City 20-400, Owner'S Manual

Page: 13 / 22

Page 13
Make sure the switch is in the off position and
the machine is unplugged.
◊ guiding oF THe BLAde
Torwards the exterior
of the frame
Torwards the interior
of the fram
3. To lock the adjustment, hold the handle with one hand
and tighten the locknut firmly with the other hand.
In order to understand better, the front guard has been
removed.
Rear bearing
lock
Locking the depth
adjustment of the
lateral bearings.
Rear
bearing
Lateral
bearings
Locking lateral
adjustment of lateral
bearings.
Eccentric adjustment of
the lateral bearings
Rear bearing
lock
Locking the depth
adjustment of the
lateral bearings.
Rear bearing
Lateral
bearings
Locking lateral
adjustment of lateral
bearings.
Eccentric adjustment of
the lateral bearings
Taking note of the note above, adjust all the bearings so
that they brush against the blade without touching it.
Locking the left side
bearing. Same for the
guiding device located
under the table.
Make sure all locking screws are properly tightened.
Refit the light plate and close the protective covers.
noTe: The set of ball bearings and plastic block
of the two guiding devices must be set to almost
touch the blade. Thus, when the machine runs
empty, neither the bearings nor the blocks are
solicited, but as soon as a sawing is in progress,
they are.
The walls of the blocks and bearings in close
contact with the blade must be parallel to it and
completely clear the sawing teeth.
The bearings must not
interfere with the setting
of the teeth.
The bearings must
touch the blade
without touching it.
wArning
!