Steel City 20-400, Owner'S Manual

Page: 10 / 22

Page 10
5. Align the compass’s passage hole from step 1 with the
passage hole in the bracket and insert the bolt removed
in step 1.
◊ PedAL
1. Remove the 2 bolts located on the emergency brake
lever.
2. Insert the pedal arm into the slot located on the right
side. Attach the arm and lever together using the bolts
removed in step 1. Tighten the pan bolts securely.
◊ PArALLeL guide
1. Using two hex bolts, two lockwashers and two washers,
assemble the two L-brackets at the front of the table.
Hand tighten for the moment.
2. Place a square nut on the holes of the brackets and
screw a handle screw from below.
3. Slide the T-slot located under the «d» profile into the
square nut of each of the two flanges. Press the profile
in d down and towards the table. Tighten both handles.
4. Using two hex screws, two lock washers, and two
washers, assemble the two L-brackets at the back of the
table. Hand tighten for the moment.
5. Insert a screw with a washer from underneath the
brackets. Screw in the last two square nuts.
7. Remove the parallel guide on the table so that the ball
bearings roll on the «d» profile.