Stecom TOPLINE, Operating Instructions Manual, Page: 35 / 62

14. LED INDICATIONS
In the following three tables, there is an overview of the LED displays on the control unit and
the extensions. There are two operating modes namely "normal operation" and "reading the
alarm memory", and in each case the LED's have different reasons for illuminating or extin-
guishing - please observe the corresponding table.
Control unit, normal operation (system is armed or disarmed)
Note:
*1 - If all yellow LED's are flashing, a general alarm signal has been received. (SS = switching
socket, MD= motion detector)
*2 - The display alternates with the actual state display.
Central Control unit, alarm memory display
LED's Green LED for siren, Red LED "active" LED "active" and
switching socket and "automatic light"
alarm switch, yellow Together / alternately
LED for detector
OFF Comp. not available / System disarmed -
not receiving
ON Normal operation / System armed -
receiving clearly
FLASHES SLOWLY Comp. reports (MD) Arming in processdelay -
Comp. active (siren / alarm triggered
switching socket) / in process
alarm switch) *1
FLASHES VERY - An alarm had been -
SLOWLY triggered, System is
rearmed
FLASHES QUICKLY Comp. Present / bad Arming of alarm in -
reception *2 process (after acoustic
warning ) or alarm is
active
FLASHES SLOWLY - - Initial operation in
(all other LED's off) process.activated
Transmission monitor
LED's OFF ON FLASHES SLOWLY
Green LED for siren, No alarm Alarm triggered due Burglary Alarm
SS and alarm switch. to tampering
Yellow LED for PIR
Seite 35 English