Pub 300 rev A
01/2011
Memory Settings
(cont.)
Control Settings
Display Settings...
• Turn on the control by pressing power button then press the TOOLS button.
• Press the DISPLAY button.
• By default the BACKLIGHT is selected. Press the left or right arrows to
adjust the backlight brightness. This setting does not work in stand-by mode.
Stand-by mode is set by factory to the lowest setting.
• To switch between °F (Fahrenheit) and °C (Celsius) press the button. Factory
default is set to °F (Farenheit).
• To switch between TEXT and ICON modes press button. Factory default is set
to the TEXT. In the ICON mode the text in each button is replaced with icons. See
Page 7 for Cross Reference guide.
• Press the power button to exit or the return button
to go back to the
prior screen.
Direct Access Audio and Light Settings...
In addition to MEMORY 1 and MEMORY 2 steam bath settings, the Light and
Audio have additional direct access settings. These two settings unlike memory 1
and memory 2 are not timed and will remain on for as long as they are left on.
• Turn on the control by pressing power button.
• Press the AUDIO or LIGHT button to access the direct access settings. This will
take you to the previously described Audio or Light menu. Make any adjustments
you like, the last setting will be remembered when you turn it off. After activating
either the AUDIO or LIGHT you can use the return button
to go back to the
prior screen to activate the other feature. Again, these settings are not timed and
will remain on.
• Press the power button to exit or the return button
to go back to the
prior screen.
Page 5
