Pub 300 rev A
01/2011
Memory Settings
(cont.)
• By default the TEMP button is pre-selected. Use the left and right arrows
to adjust steam temperature.
• Press the power button to exit or the return button
to go back to the
prior screen.
For new users, Steamist recommends you start with a temperature setting
between 102°F and 110°F. Once you are accustomed to steambath temperatures,
you can select a higher or lower setting.
NOTE: To turn the steam off while making other adjustments, reduce the tempera-
ture to the lowest setting.
Time Settings...
• Press the desired personal setting button, MEMORY 1 or MEMORY 2 then press
the STEAM button.
• To increase the remaining time left while steambathing, press the TIME LEFT
button and the remaining cycle time in minutes is shown. Use the left and right
arrows to adjust the time from 0 to 60 minutes. Adjusting the time in this
window only alters the current cycle.
• To adjust the default cycle time for the current memory setting press the CYCLE
TIME button. Then use the left and right arrows to adjust to the desired
time.
• Press the return button
to save the setting and go back to the prior screen.
AromaSense
™
Settings...
• Press the desired personal setting button, MEMORY 1 or MEMORY 2 then
press the STEAM button.
• If your Total Sense
™
system is equipped with the AromaSense
™
option the se-
lected pump (AROMA1, AROMA2 or AROMA OFF) will be shown on the screen.
• Press the AROMA button to switch between pumps or to turn off the Aroma
pump.
• Once desired pump is selected use the left and right arrows to adjust the
intensity of the AromaSense
™
oil.
- The lowest ON setting is slightly less than one drop per minute.
- The highest ON setting is approximately five drops per minute.
• To turn the AromaSense
™
option off press the AROMA button until it changes to
“AROMA OFF”.
• Press the power button to exit or the return button
to go back to the
prior screen.
To purchase replacement containers of
AromaSense
™
Essential Oils, visit
www.steamist.com.
Page 3