Rev 3/2012
23 |
P a g e
Power on/off
Push any button to light the display, and
press the power on/off switch to start the
system, as shown by Picture 2. Push the
power on/off switch again to turn off the
system and display. The drain valve for
the steam generator stays open for one
minute.
Steam Temperature Setting
Hold down the Steam Temperature Setting
button and the display shown in Picture 3
will show. The temperature ranges from
20 to 59 circularly. Let go of the button
when the desired temperature has been
reached, and the figure is set as a steam
setting. The steam generator stops
working when the temperature inside is 4
degrees higher than setting temperature.
The steam generator automatically starts
working when the temperature is 4
degrees lower than the setting. The default
steam setting is 113 degrees if the user
does not make any setting.
Steam Time Setting
Hold down the Steam Time Setting button
and the display shown in Picture 4 will
show. The figure changes circularly from
20-59 minutes. Let go of the button when
the figure reaches the desired time and is
set as the working time for the system.
The system is automatically set to turn off
when the set time or to 45 minutes
(default system time).
Summary of Contents for WS-112
