STEALTH DIGI-CUT 60-1
9
4. OPERATION CONTROL AND CONNECTORS
1. Cutting current regulator – used to regulate the current when cutting.
2. Power pilot lamp – turn on power, the lamp is lit.
3. Alarm pilot lamp – Pilot lamp indicates when lit that the protection of the machine has
been activated.
4. Cutting gun incorrect installation and air pressure low alarm:
(a) When a sudden short circuit occurs between the electrode and the nozzle the lamp
is lit and air feeds intermittently.
(b) When the cutting gun without electrode and nozzle is installed, the lamp is lit and air
feeds
intermittently.
(c) Lamp flashes when the Shield Cup is not installed.
(d) When the air is low, the lamp is lit
5. READY (DC Indicator) – Indicator is ON when DC output circuit is active.
6. RUN/SET – When cutting the workpiece, turn to ‘RUN’. When performing a gas test, turn
to ‘SET’.
7. Cutting gun connector – Connect to the cutting machine.
8. Positive output cable – Connect to the workpiece.
9. Barometer – Ensure there is no impurity and moisture in the compressed air.
10. Mains cable – Connect to the appropriate power supply.
11. Power switch – Turn on or off the power source.
5
§4 Operation
4.1 Layout Of The Front And Rear Panel
1.
power pilot lamp:
turn on power, the lamp on.
2.
over-current ,over-heat alarm:
when over-heat, over-current, the lamp would be on.
3.
cutting gun improper installation and air pressure low alarm
(1)when short circuit occurred between the electrode and the nozzle for abnormal reasons, the lamp on , air feeds
intermittently.
(2)when cutting gun with no electrode and nozzle installed, the lamp on, air feeds intermittently .
(3)when the Shield Cup is not installed, the lamp flashes.
(4)when the air low, the lamp on
4.
voltage pilot lamp:
turn on the switch of the cutting gun, generate the voltage, the lamp on
5.
RUN/SET:
when cutting the workpiece, turn to the “RUN”; when doing gas test, turn
to the “SET”.
6.
compressed air connector
7.
power switch:
turn on or off the power source
8.
power cable:
connected to the appreciate power supply
9.
cutting current regulator:
it is used to regulate the current when cutting.
10.
Cutting gun connector
11.
positive output cable:
connected to the workpiece