-
12
-
gb
ASSEMBLY
Battery charging
Use only the battery chargers listed on the
accessories page.
Only these battery chargers are
matched to the lithium ion battery of your power tool.
Note
: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge the
battery in the battery charger before using your power
tool for the first time.
The lithium ion battery can be charged at any time
without reducing its service life. Interrupting the charging
procedure does not damage the battery.
Do not continue to press the On/Off switch after the
machine has been automatically switched off.
The
battery can be damaged.
To remove the battery 5, press the battery unlocking
button 9 and pull the battery out of the power tool toward
the rear.
Do not exert any force.
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range
of between 0º C and 45º C. A long battery service life is
achieved in this manner.
Observe the notes for disposal.
TOOL ASSEMBLY
Changing the Upper blade (2)
1- Follow the steps described in point 3 of the manual to
activate the tool by opening the blades.
2- With the blades open, deactivate the safety switch (6)
leaving it in position O and remove the battery (7).
3- Remove the hexagonal screw (3) by turning
anticlockwise using the hexagonal spanner (9).
Then remove the hexagonal nut (5) by also turning
anticlockwise. Remove the washer.
4- Use the hexagonal spanner (9) to unscrew the 2 screws
that hold the head housing, extracting the part that covers
the blade insert.
5- Remove the retaining ring (A) from the retaining arm
(B) using pliers. With the blade (2) released, you can
remove it and install a new one by following this sequence
of steps in reverse.
6- Apply lubricant (10) to the new blade (2). When
installing the housing part, make sure that it is aligned
with the rest of the structure and that the fastening screws
fit correctly. Before using the tool, make sure that the
pressure between the blades is correct.
CAUTION: Use only original STAYER spare parts. The
use of other components can lead to accidents and
injuries.
Adjusting the pressure between the blades (1-2)
It is necessary to adjust the pressure between the blades
from time to time in order to keep the tool in good working
conditions.
1- Follow the steps described in point 3 of the manual to
activate the tool by opening the blades.
2- With the blades open, deactivate the safety switch (6)
leaving it in position O and remove the battery (7).
3- Loosen the hexagonal screw (3) by turning anticlockwise
using the hexagonal spanner (9).
4- Adjust the pressure of the blades (1-2) using the internal
hexagonal spanner (11). Increase the pressure by turning
clockwise, release the pressure by turning anticlockwise.
5- Reassemble the machine by repeating steps 1, 2 and
3 in reverse order.
CAUTION: Correct blade pressure is a decisive factor
in the performance of the tool.
If the blades are too loose, the cut will be of poor
quality and the branch debris will get stuck in the
blades.
Excessive pressure will strain the tool's motor and
reduce the tool's life and wear the blades.
When the shears are closed there should be no gap
or movement between the blades.
A
B
