StarTrac 263-4WD-8G-STAGE-V, Owner'S Manual, Page: 65 / 100

65 | P a g e
OWNER’S MANUAL | STARTRAC 263 4WD – 8G – STAGE – V
•
If needed fill up through the position to the required level with oil of
prescribed type.
•
When operating extreme hydraulics, such as hydraulic front loaders,
rams’ motors etc. that require a certain amount of oil top up the
additional oil of about 3-5 liters oil.
•
This ensures a correct oil level in the transmission at any time.
•
The level must never be under the Min. mark when using external
hydraulics.
•
The level must always be between the Min and Max marks.
•
When working with the tractor with the slopes, add extra liters of oil to
guarantee a minimum oil level even in the most difficult conditions.
•
The hydraulic ram of the implements being hitched to the tractor
contains the same oil used in the transmission of the tractor.
•
This excludes any oil contamination that could cause malfunction.
If leak is found and any other defect that cause the oil level to drop, immediate
action is required to avoid any damage to mechanical systems.
Check at regular intervals the oil level in the gearbox, the rear final drives and in the
hydraulic lift and steering circuits.
Park the tractor on the flat ground, stop the engine and lower the hydraulic lift links.
See the lubricants and fuel chart for the type of oil to be used according to the
transmission type.
5.20 RECOMMENDED GEAR OIL VISCOSITY
ACCORDING TO AIR TEMPERATURE
•
We recommend use of SAE-5W30 UTTO oil grade for
transmission and oil brakes.
•
Refer the chart for appropriate oil viscosity according to the
ambient temperature.
5.21 FRONT DIFFERENTIAL OIL LEVEL
•
Oil filling plug (A) is provided on right hand side of the front
axle (as shown in fig.).
•
Open the plug and check the oil level.
•
The lower point of the plug should be immersed in the oil.
•
Front Differential Oil Capacity: 2.5 Liters
•
Oil Grade: SAE-5W30 UTTO
Fig.5.5
Fig.5.6
Fig.5.7