SV1110IPEXT Instruction Guide
12
The Admin/Setup Screen
This is the menu that will allow you to access all the features you will need to perform an
initial configuration of the SV1110IPEXT. Each of the options is explained in detail
here.
Network Configuration (IP address. Netmask, etc)
Dynamic Host Configuration Protocol (DHCP)
Automatic network configuration using DHCP is:
Enabled/Disabled.
This feature applies only to the
LAN
port on the rear panel, and is enabled by
default. When enabled, the unit will automatically configure itself with an IP
address when a
DHCP server is
present. When
disabled, the
LAN
port will
use the values
assigned to it
on the
IP
Addresses and
Routing
table
below.
Current DHCP Lease Information
This box provides detailed information about the IP lease that the unit has
obtained from the DHCP server.
IP Addresses and Routing
This table allows you to assign IP information for the
LAN
and
WAN
ports
separately. If you are using DHCP, the values for the
LAN
port will be filled in
automatically and
any changes made
will not affect the
setup. If
Ethernet
Bridging
is
enabled (see
below) the
WAN
port will use the
same settings as
the
LAN
port, and
any changes will
not affect the setup
for that port.
Adjusting the
setting for the
WAN
port allows
